Caple CE1500 Spécifications télécharger pdf (Page 15)

PanelView Plus 700 to 1500 and PanelView Plus Compact 1000 Terminals and Display Modules 15

Publication 2711P-IN001I-EN-P - November 2009

Ethernet Wiring

Use Belden 7921A shielded Ethernet Category 5e cable according to TIA 568-B.1 and RJ45

connector according to IEC 60603-7 for compliance with Marine emissions limits and

European Union 89/336/EEC EMC Directive.

The maximum cable length between the terminal’s Ethernet port and a 10/100 Base-T port

on an Ethernet hub (without repeaters or fiber) is 100 m (328 ft).

Remove and Install the Power Terminal Block

The terminals are shipped with a power terminal block installed. You can remove the terminal

block for ease of installation, wiring, and maintenance.

• Series A to D, DC logic modules use a 3-position terminal block.

• Series E or later, DC logic modules use a 2-position terminal block.

• All logic modules with an AC power input use a 3-position terminal block.

WARNING

Explosion Hazard

Substitution of components may impair suitability for hazardous locations.

Do not disconnect equipment unless power has been switched off and area is known to

be nonhazardous.

Do not connect or disconnect components unless power has been switched off.

All wiring must comply with N.E.C. articles 501, 502, 503, and/or C.E.C. section 18-1J2 as

appropriate.

Peripheral equipment must be suitable for the location in which it is used.

ATTENTION

Disconnect all power before installing or replacing components. Failure to disconnect

power may result in electrical shock or damage to the terminal.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

Pas de commentaire

Caple CE1500 Spécifications Page 15