Caple VITROCERAMIC HOB Manuel d'utilisateur télécharger pdf (Page 30)

You can change the standard settings

of your hob.

With the hob switched off, touch the

hob ON/OFF sensor s and the

booster sensor B at the same time,

until P (Programme), S (Status) and

numbers appear in the cooking zone

displays. This shows the current

setting.

To set the programme:

Touch the sensor for the front left

cooking zone.

The relevant number will begin to flash.

^ Touch the + or - sensor to set the

required programme.

To set the status:

Touch sensor for the front right

cooking zone.

The relevant number will begin to flash.

Touch the + or - sensor to set the

required status.

To store the new settings in memory,

touch the B sensor until the displays go

out.

If you do not wish to store the settings

in memory, touch the ON/OFF sensor

until the displays go out.

Programme Status* Setting

P0 Demonstration mode and factory

default settings

S 0 Demonstration mode on

S1 Demonstration mode off

S 9 Factory default settings

reinstated

P1 Keypad tone when a sensor is

touched

S 0 Off

S1 On

* The factory default settings are shown in bold.

Programming

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 47 48

Pas de commentaire

Caple VITROCERAMIC HOB Manuel d'utilisateur Page 30