Caple C702G Manuel de service télécharger pdf (Page 125)

7-37

18. AUTO ADJUST CIRCUIT FAILURE

Set signal all white characters, and perform AUTO ADJUST on OSD control.

When check the following contents, perform AUTO ADJUST at the each time.

Make sure that the voltage of C8M7 is approx. +5.0V and C8MF is approx.+3.3V.

Check the waveform at IC8M1 pin 27,pin 28 and pin 29.

(Approx. +3.2Vp-p)

Check the waveform at IC8M1 pin 14.

(Approx.+5.0Vp-p)

Check the waveform at IC8M1 pin 13.

(Approx. +5.0Vp-p)

V. frequency

H. frequency

V. frequency

Check +5.0V and +3.3V

+5.0V line, IC8M2 or IC8G2 failure on the VIDEO PWB.

Check R.G.B video input signals

Q8M1R, Q8M1G and Q8M1B failure separatel

or VIDEO CIRCUIT FAILURE. (See item 2)

Check AFC_TTL input signal

CNASD pin 4 or AFC_TTL line failure.

Check V.PUMP input signal

CNASD pin8 or V_PUMP line or its ambient circuit failure.

Re-adjust Auto Adjust adjustment (Set again AUTO ADJUST L and AUTO ADJUST H)

Failure IC8M1or it's ambient circuit failure.

The video signal was not possible for working correctly of Auto Adjust function.

1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 285 286

Pas de commentaire

Caple C702G Manuel de service Page 125