Caple C702G Manuel de service télécharger pdf (Page 85)

6-5

3. CRT

[A] CRT face plate defect

1. Inspection condition

1) In the operating condition, observe the defect on the screen under following condition :

9,300K (

x=0.281,

y=0.311)

white raster or the element monochrome raster which its brightness is 34cd/m

(10ft

･

L) on the screen

center surrounding light is about 10 Lux

2) In the non-operating condition, observe the defect of the screen under light of about 200 Lux,

measured at the faceplate.

3) Inspection shall be made more than 45 cm away from the screen.

4) Observe the screen on white raster and each monochrome color of red, green, and blue.

2. Division of zone

A screen is divided into following 2 zones.

Zone A: Area inside the rectangle that its size measures H: 395 mm, V: 295 mm in the center of screen.

Zone B: Area outside the above rectangle

3. Limits

3-1. CRT face defect

3-1-1. Distance (minimum distance)

3-1-2. Average diagram

Turn of

small value into an on the average diameter. (a: length, b: width)

3-1-3. Limit

- Dark spot, Blocked aparture

Average diameter(mm) A B A + B minimum distance

0.51 ～

000 -

0.31 ～ 0.50

000 -

0.15 ～ 0.30

6 (note 1) 6 (note 1) 10 (note 1) 10 mm

- Discoloration, stain, Missing phospher, etc.

Average diameter(mm) A B A + B minimum distance

0.51 ～ 0.75

0 1 - 20 mm

0.15 ～ 0.50

2 3 - 20 mm

Note 1: No missing spot larger than specified are allowed in Zone A.

Note 2: The spec. applies to each color.

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 285 286

Commentaires sur ces manuels

Pas de commentaire

Caple C702G Manuel de service Page 85

Commentaires sur ces manuels

Produits connexes et manuels pour Plaques chauffantes Caple C702G