Caple C804C Spécifications télécharger pdf (Page 132)

HPOD C-, X-, Ku-Band High-Power Outdoor Amplifier MN/HPOD.IOM

Appendix B Revision 8

B–2

In 1:1 applications, the BU also stores an offset value, to be used when the BU replaces the

active unit. This offset may be set with the GOF= command. When the online unit is being

“backed up” the BU’s attenuator will be set to this value. This value may be different than the

attenuation value of the online unit to compensate for any gain mismatch between the BU and

online units.

To calibrate, do these steps:

Step

Task

Identify the unit with the most gain.

Calculate the actual error.

To compensate for the error, set the GOF= command in the unit having the highest error. For example – If

SSPA 1 has 70 dB of gain, and BU SSPA 2 has 72 dB, send the GOF=2.00 command to the BU SSPA 2 to

store these values.

B.1.2 1:2 Redundancy Mode

Figure B-1 shows the block diagram for an HPOD 1:2 Redundancy System. For the purpose of

example, this figure shows a C-Band system.

Figure B-1. HPOD C-Band 1:2 Redundancy System Block Diagram

In 1:2 redundancy mode there is a dedicated BackupUnit (designated as BU) as determined by

the cable position. In this configuration, the BU is responsible for monitoring the two online

units for communications and summary faults.

1 2 ... 127 128 129 130 131 132 133 134 135 136 137 ... 149 150

Pas de commentaire

Caple C804C Spécifications Page 132