Caple C602E Manuel d'installation télécharger pdf (Page 21)

Revision 1.9 - 21 -

Control power wiring setup

To maintain the best possible power supply, install the auxiliary batteries as close as possible to the gate.

- Truck installations might not have an auxiliary battery kit (PALFINGER Liftgates always recommends

a kit). In this

case you have to run the control power straight off the truck battery.

- Trailer installations always have a battery kit (at least 2 batteries) attached to frame on driver side

Connect your control power to the positive (#2 & #4) and the negative (#1 & gr/ye) post of the batteries.

Control Power 4-Wire Cable

Truck Application-Always wire to truck battery

Trailer Application-wire to aux. battery

20 Amp

In-Line

Fuse

Wires marked

#2;#4 (Black)

go to hot,

#1 and green/yellow

go to ground

PC-board

15 Amp fuses

J1 Plug

gr/ye

J2 Plug

Optional:

Main power

on/off switch

Figure 13 Board control power wiring connection

Ground Cable

Ground

at frame

(Third Battery Shown

for heavy applications Only)

Liftgate Mount Frame

Main Truck

Batteries

2 Ga. Liftgate Power Cable

Ground

To Ignition

Switch

Ground

Aux. Batteries

Battery

Isolator

(if applicable)

Circuit

Breaker

Circuit

Breaker

Figure 14 Main Power supply setup

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 39 40

Commentaires sur ces manuels

Pas de commentaire

Caple C602E Manuel d'installation Page 21

Commentaires sur ces manuels

Produits connexes et manuels pour Plaques chauffantes Caple C602E