Caple C602E Manuel d'installation télécharger pdf (Page 34)

Revision 1.9 - 34 -

Slide angle sensor

B-15 Lift arm

Voltage difference

between store and

slide position

0.34 V @ blue

1Meg Ohm Resistor

a. Attach your digital voltmeter to the blue (signal) and brown (ground) cables on the J-41 plug

b. Voltage should be between 1.4V and 1.6V with gate in stored position

i. If necessary rotate B-15 lift arm sensor within oblong hole to achieve voltage range

ii. After adjusting B-15 unplug and reattach J-1 plug for reset the signal to board

3) With sensor fine-tuned and gate activated, run gate through (2) full cycles.

a. Slide gate out and LOWER to floor. Activate “slide in” function. Gate will raise and lift at the

same time until preset slide level is reached. Gate will slide in and lift up into travel position

when reached end position.

b. Slide gate out and LIFT to truck bed. Activate “slide in” function. Gate will lower until preset

slide level is reached. Gate will slide in and lift up into travel position when reached end

position.

Oblong hole in B-15 sensor

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 40

Pas de commentaire

Caple C602E Manuel d'installation Page 34