Caple C602E Manuel d'installation télécharger pdf (Page 23)

Revision 1.9 - 23 -

5.4.2

Slider rail stops setting

Figure 17 Slider rail stops

• For final adjustment, lift the platform all the way up till it is level with the truck/trailer floor

• Choose the hole that is the closest to the mount plate in the slider rail

• Install the bolt and tie it down in each side.

• Use the same hole on each side to assure an even position of the platform with the body.

5.4.3

Control box installation

Determine location for control box; locate it in a way that the operator can view the platform and surrounding

areas while operating the liftgate.

4 Hot/Power

6 down

5 up

Hot-#4.3- yellow / green

Up-#5.2- wire 1

Down-#6.2- wire 2

Slide In-#3.2- 80 - wire 4

Slide Out-# 81- wire 3

Flush Mount 3 Button Control

3 4

1 2

3 4

Hot-#4.3- yellow / green

Slide In-#3.2- 80 - wire 4

Up-#5.2- wire 1

Down-#6.2- wire 2

Slide Out-# 81- wire 3

( Toggle-#4 )

( Toggle-#5 )

( Toggle-#6 )

Toggle Switch (Optional)

Optional

Figure 18 Flush mount Control box wiring

• Run the 5-wire harness, coming out of the main wire loom, to the control box. Run the wire inside the

body and connect wires as shown in Figure 18.

• Make sure all jumpers inside the control are set and cables are tight at the contact blocks.

Holes for

slider stop

adjustment

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 39 40

Pas de commentaire

Caple C602E Manuel d'installation Page 23